Finninno battery mold
For the efficient manufacture of high-quality concrete partition walls
We manufacture battery molds according to the customer’s needs and wishes, as one-sided or two-sided molds.
Very strong mold structure
The structure in the support walls and intermediate walls of our battery mold is so rigid that the concreting cells can be cast full one at a time. This expedites considerably the concreting of the battery mold.
Easily maintained heating tubes
We can supply the battery mold with heating tubes that use hot water circulation. This accelerates the strength development of the precast concrete sections. The tubes can also be installed afterwards. Thanks to the innovative mold design we have devised, the heating tubes can be maintained very easily, if necessary.
Strong and high-quality Finninno battery mold
- the mold is manufactured with one or two sides
- number of casting cells according to the customer’s wishes
- mold surface of 8 mm thick steel plate
- fixed and movable support walls and movable intermediate walls
- the casting cells are equipped with end closures and steplessly adjustable bottom closures
- the molds can be provided with easily-maintained heating tubes that use hot water circulation, built inside the intermediate walls and support walls
- reinforced wall structure, side hinges and bottom side adjustment screws, tensioning
- cylinders and pull bars
- equipped with a hydraulic unit, and hydraulic piping, hoses and connectors mounted in the mold
- contains the base beams, transfer rails and transfer keys
- railings, platforms and stairs are included in the delivery
- the battery can be vibrated by a poker vibrator.
The battery mold can also be delivered without a hydraulic unit to be tightened mechanically. In this case, it comes cheaper than a hydraulic battery mold.
The customer can choose to prepare the railings, platforms and stairs using plans submitted by us.