Elevator shaft sections with extreme dimensional accuracy enable easy installation and faster work steps, and ensure that construction work at the site is sure to run smoothly.
The precast sections made with the Finninno Elevator Shaft Mould are exceptionally accurate in terms of their dimensions and always identical. This speeds up the installation of elevators and decisively shortens the finishing work steps, which reduces construction costs.
The elevator shaft mould is a cost-effective and fast way to cast high-quality concrete sections both in precast concrete section factories and at construction sites. It eliminates unnecessary production steps and significantly improves production efficiency as compared to other production methods. A single mould can produce as many as three precast concrete elevator shaft sections in just 16 hours, and 3,600 elevator shafts per year.
The same elevator shaft technology can be utilised in the manufacture of other shaft-like sections, such as bathroom sections.
The high-quality moulds designed by us are manufactured in Kotka, Finland, and they have been used by the construction industry in Finland and Russia since 2002.
Investment that will pay itself back quickly
The payback period of the elevator shaft mould is about 40 production days, in other words only two months, when three elevator shaft sections are cast in one working day.
Finninno Elevator Shaft Mould saves time, costs and resources
1. Only one full section per floor
No more four separate walls that need to be connected to each other. Fewer tools, work stages and machines are needed, which also shortens the time taken by the work.
2. Easier work for elevator installers
A precisely measured, ready-made elevator shaft makes the work of elevator installers smoother, and the need for extra adjustment is eliminated. Fluent work saves time and resources.
3. Work runs smoothly in a clean environment
When there are fewer installation supports, there is more space available to work in staircases or stairs, and the work environment remains tidy.
Inner mould, product on the concreting base, and outer mould. The height of the mould is normally about 3 metres, depending on the height of the floor and the needs of the customer. The width and depth of the mould can be customised according to the customer's needs. The maximum dimension is 4 metres per side.